Hi Gang,
I am planning on installing an 04 CDL lever this weekend. After watching Justin's video, and reading a couple of articles on the install process, I have a question. I understand that I need to drill out some pop rivets to release the transfer lever mounting plate, as described in the step below.
STEP 10
Once the heater ducts are removed, you can then start to drill out the 13 pop rivets that hold the transfer lever mounting plate in position, once they are all drilled you can manoeuvre the plate out of position. It wont come right out as its still got the cable connected underneath
When I am refitting everything, what happens to this plate, now that the rivets are drilled out? Do I need to use pop rivets to refit this plate? I know this sounds noob, but I've never had to rivet anything, and I'm a little unsure what size I need, etc. Any help would be much appreciated.
Thanks
Dave
I am planning on installing an 04 CDL lever this weekend. After watching Justin's video, and reading a couple of articles on the install process, I have a question. I understand that I need to drill out some pop rivets to release the transfer lever mounting plate, as described in the step below.
STEP 10
Once the heater ducts are removed, you can then start to drill out the 13 pop rivets that hold the transfer lever mounting plate in position, once they are all drilled you can manoeuvre the plate out of position. It wont come right out as its still got the cable connected underneath
When I am refitting everything, what happens to this plate, now that the rivets are drilled out? Do I need to use pop rivets to refit this plate? I know this sounds noob, but I've never had to rivet anything, and I'm a little unsure what size I need, etc. Any help would be much appreciated.
Thanks
Dave