95 Disco Indicators act like hazards

[twosevens]

Looking for ideas on where else to look. I've replaced all bulbs, swapped the switch, hazard switch, unhooked the battery overnight, and checked all grounds. Still flashing at all four corners. I am having issues with the alarm module and looking for a replacement, so perhaps that might have something to do with it, but I dunno until I can swap it out.

Thanks

 

[twosevens]

That said, I'm looking for a module -

AMR4110​

 

[WaltNYC]

So what did you do to your Disco today? - Land Rover Forums - Land Rover Enthusiast Forum

Discovery I - So what did you do to your Disco today? - We have a post like this on the Porsche forum that is fun to read and add to on a daily basis. I searched and didn't see anything on the Disco 1 side so I figured give it a shot and see if people contribute. I'll start. Put in a new...

landroverforums.com

start at this post and you may not need a module.

Removing the board is easy enough...

 

[twosevens]

So what did you do to your Disco today? - Land Rover Forums - Land Rover Enthusiast Forum

Discovery I - So what did you do to your Disco today? - We have a post like this on the Porsche forum that is fun to read and add to on a daily basis. I searched and didn't see anything on the Disco 1 side so I figured give it a shot and see if people contribute. I'll start. Put in a new...

landroverforums.com

start at this post and you may not need a module.

Removing the board is easy enough...

I've inspected the board and found a few suspect spots from moisture damage. I'd really like to swap it for one that looks healthier. This video is interesting though. Appreciate it!

 

[German Gruner]

You may check indicators without alarm connected, to be sure about the culprit

Regards

 

[4Runner]

Will it start? Don’t the hazard lights come on when the inertia switch is tripped?

 

[Frobisher]

Will it start? Don’t the hazard lights come on when the inertia switch is tripped?

The hazard lights reset with a restart if the inertia switch has been tripped. I just learned that recently.

 

[Jimmy]

Will it start? Don’t the hazard lights come on when the inertia switch is tripped?

Yes they do. I was hoping someone brought this up.

@twosevens Have you reset your inertia switch, or considered it as the culprit?

 

[twosevens]

I reset the inertia switch already. The truck starts and drives fine. I did unplug the alarm module and all lights worked fine, but this was before dealing with this fault.