99 d2 fault codes

[discolvr71]

hi i have a 99 d2,i just picked up.the previous owner told me he was driving it one day and the engine quit.
i charged the battery and it started right up.at start up it runs a little rough,then idles well afterwards.
i checked the codes and i got these,p-1884,p-1843,po-600,po-308,p-1590.i also have the 3 amigo's,oil pressure light on.what would be best place to start checking.

thankyou

 

[KyleT]

p1884 CAN message invlalid
p1843 Limp mode
p0600 Serial Communication Link Malfunction
p0308 cyl 8 misfilre - bad plug wire
P1590 rough road signal - related to abs lights

get the rave. you are pretty much dealing with a whole lot of different issues. Any rats or squirrels under the hood?

TCM module sounds like it is bad or maybe the grounds are bad.

low oil pressure, if the switch isnt bad, then the pump is bad or a cam bearing fell out. if you are into it with alot of cash, i would run as most of this stuff is going to get expensive.

 

[roverover]

Clear the codes and see what comes back

 

[jafir]

Clear the codes and see what comes back

Yeah. A lot of those codes will get stored if the battery was ever low or disconnected.

 

[discolvr71]

hi,so i changed the oil and filter,and the oil light went out,i reset the codes,and i got p-1590 and the 3 amigo's still.how should i check the abs system.

thankyou

 

[jafir]

Need a special reader for the abs. Abs amigo, nanocom, hawkeye, that kind of thing.

 

[capri_auto]

Get the charging system checked at autozone it may have quit because of a bad alternator. Also pick up an abs amigo you can probably get ones used on one of the forums.

 

[LRNationals]

good report about http://www.nveuromotor.com/ may want to stop by.