ABS, TC, and Hill Decent lights on. Help!

chizychiz

Well-known member
Jun 8, 2004
139
0
Louisville, KY
I have a '99 DII, and the other day the ABS Light, Traction Control light, and Hill Decent light came on while driving. It has done this occasionally when I have had the transfer case switch to low, but I have always been able to get rid of it by switch the T-case back to high and running for about a half mile. This time the lights came on while in high. And I can't get them to go out no matter what I do. I am assuming that one of the ABS sensors have gone bad, but I'm not sure. One question I have is if the brake pads are worn all the way down, will it cause this error? I haven't checked my pads in awhile, and though I think they are still good, maybe this is the issue. Any ideas?

*J*
 
M

mojowebcast

Guest
Most likely an ABS sensor. I had the 3 lights turn on and off now and then and then they just stayed on. Had the dealer fix the problem because they are only a block away from my office.
 

DeanBrown3D

Well-known member
Apr 29, 2004
765
0
www.discoweb.org
Can the sensors be tapped down into the sockets, like on the d1?

*J* check the sensor wires - maybe one of them is rubbing and shorting out partially?
 
C

canadianfrenchguy

Guest
i got the same problem here what i found

1; verify all 4 bearing wheels by shaking tires, if all are ok then you have to use an obd2 find the troubleand make appropriate fix


2; if one of your bearing is or become dead, it will do a small scratch on your abs sensor.


3; you will need to change as the bearing wheel bearing or hub and the sensor this is why they sel the hub bearing with the sensor.

sorry for spelling mistakes...i m a french canadian