Brake servo vacuum pipe removal

[sbsrlewis]

Never mind I finally figured it out.

I'm in the process of removing the heads from my 01 DII. RAVE repair page 30-2-17 says to disconnnect brake servo vacuum pipe from inlet plenum. How does it come out? I've been prying on it but am afaid I'm going to break it.

Thanks
Steve

 

[mlnnc]

Can someone please go ahead and answer this question? I broke off the brake servo pipe near the plenum and can't figure out how to remove the broken stub that is still in the plenum port. The red collar is gone from the outside of the plenum but its remnants and the end of the broken pipe are still in the plenum port and will not come out. There is a larger plastic "grommet" that both mount inside. It turns but does not unscrew. HELP PLEASE!

Thanks.

 

[mlnnc]

Please?

 

[ratboy]

Please?

? im not sure what to do other than finish destroying it and get a whole new/used assembly. without being able to look at it. you have to push the red collar in then pull out the tube. if the collar is gone...