Just checking the market here.
Basic Info
01 D2 Black SE
76,000 miles
New top end gaskets
New plug wire
Transmission fluid and filter change
Valve job this summer
Rebuilt front driveshaft with greaseable u-joints last year
Synthetic fluids for last 20,000 miles
Minor wreck in August of 04, all repair work done at a reputable garage
The Bad
Baseball sized dent in drivers side fender
Golf ball sized dent and 6 inch scratch in passenger side rear door
Rear door sticks a bit but still locks and opens just fine
ABS shuttle valve is gone, ABS fuse pulled
Washer bottle not installed
The Good
OME HD 3" springs and shocks(matched springs from EE)
OME steering damper
(5) 255/85R16 BFG MTs (around 4000 miles, spare never seen ground)
Trek Outfitters steel wheels
RTE front bumper
Superwinch EP9.0
RTE sliders
Greg Davis rear bumper
Custom 4340 axle shafts
Rear Detroit locker
U-Jointed rear driveshaft (from a RRC)
RTE front diff guard
HD drag link and tie rod
Marc Olivares rear pinion guard
Southdown rear gas tank skid
D1 CDL linkage
D1 rear spring perches (+.75" lift)
D1 wiper arms
Flowmaster 50 series with resonator cut off
Optima Red Top
Jotto Desk
04 cupholders
CB with 2" K40 atenna on rear tire carrier
Hi-Lift
2 2" straps (20' and 30'), Tree saver
Asking $11,000.00
PM me if you are interested, but once again, I'm just feeling things out.
Basic Info
01 D2 Black SE
76,000 miles
New top end gaskets
New plug wire
Transmission fluid and filter change
Valve job this summer
Rebuilt front driveshaft with greaseable u-joints last year
Synthetic fluids for last 20,000 miles
Minor wreck in August of 04, all repair work done at a reputable garage
The Bad
Baseball sized dent in drivers side fender
Golf ball sized dent and 6 inch scratch in passenger side rear door
Rear door sticks a bit but still locks and opens just fine
ABS shuttle valve is gone, ABS fuse pulled
Washer bottle not installed
The Good
OME HD 3" springs and shocks(matched springs from EE)
OME steering damper
(5) 255/85R16 BFG MTs (around 4000 miles, spare never seen ground)
Trek Outfitters steel wheels
RTE front bumper
Superwinch EP9.0
RTE sliders
Greg Davis rear bumper
Custom 4340 axle shafts
Rear Detroit locker
U-Jointed rear driveshaft (from a RRC)
RTE front diff guard
HD drag link and tie rod
Marc Olivares rear pinion guard
Southdown rear gas tank skid
D1 CDL linkage
D1 rear spring perches (+.75" lift)
D1 wiper arms
Flowmaster 50 series with resonator cut off
Optima Red Top
Jotto Desk
04 cupholders
CB with 2" K40 atenna on rear tire carrier
Hi-Lift
2 2" straps (20' and 30'), Tree saver
Asking $11,000.00
PM me if you are interested, but once again, I'm just feeling things out.
