O.K. The bar that goes between the hubs (Panhard Rod ?) I've bought an adjustable one. Is there anyplace that sellls a way to connect the steering stabilizer on it? Because I've just flat out welded a "tab" onto it to attach the stabilizer. But am in need of an alignment. I'm drawing a blank on where I bought it from to see if the sell a attachment for the stabilizer that's adjustable! Any help would be nice.
D II steering stabilizer?
- Thread starter scottagnew101
- Start date
The track rod goes between the hubs, the drag link goes between the steering box and one hub.
The drag link carries the steering damper lower connection.
Panhard rod locates the axle relative to the chassis on a side to side basis.
Peter
The drag link carries the steering damper lower connection.
Panhard rod locates the axle relative to the chassis on a side to side basis.
Peter
Thanks Peter, does anyone sell a contraption to hold the stabilizer and to let it roll?
Last edited:
I made one using a tube clamp from ballistic fabrication. Alignment is super easy. Only toe is adjustable and if you didn't change the tie rod then just adjust the drag link until the steering wheel is straight. Ill snap a pic of mind.
