D1 90 degree knock sensor

[veefly]

Installing headers and D1 and picked up a D2 90 deree knock sensor to use on the driver side. The hole on the D2 knock sensor is smaller than the bolt I would use to screw it to the block. Question is do I drill out the hole larger or do I have to make a special bolt or adaptor to install the D2 90 degreee sensor on my D1.

Thanks in advance

 

[crown14]

Installing headers and D1 and picked up a D2 90 deree knock sensor to use on the driver side. The hole on the D2 knock sensor is smaller than the bolt I would use to screw it to the block. Question is do I drill out the hole larger or do I have to make a special bolt or adaptor to install the D2 90 degreee sensor on my D1.

Thanks in advance

When I sell 90 degree knock sensors, I sell the special studs with them. What you need is part number LYR100740.

 

[veefly]

Thanks for the response, PM you about picking up a couple if possible.