D1 and D2 Interior Bits

[Alabama Rover]

Are there any items from a D2 Interior that will fit a D1. I have found a D2 at a local scrap yard and the guy is willing to give me a pretty good deal on it. Mine is a 98 D1, the one at the scrap yard is an 02 D2. I would really like to change the front seats out, and the back storage bins. The Headliner was in pretty good shape also. Will any of those fit?
Thanks

 

[Quentin]

I doubt it.
What model D2 is it?

 

[Alabama Rover]

2002

 

[crown14]

wont fit

 

[fishEH]

You can probably make just about any seats fit if you can weld. A friend of mine has an old set of Acura RSX seats in his D1. Those things are waaaaaaaay comfortable.

 

[Alabama Rover]

Thanks, I did not think they would fit, just wanted to confirm

 

[desertdude]

The center facsia cover will fit ( The one with the radio and AC controls ) You will get a few etc non working buttons though like HDC and center door lock. I just swapped one into a friends 96's D1 from a 02.

This thing

http://www.dragtimes.com/images-cla...r-Dash-Panel-Fascia-for-sale_330523137576.jpg

I think, not sure the center console where the gear lever is till the cubby might fit.

Other than that I can't think of anything else that might fit.

 

[11b4v]

tangent here, but do you know the kid who works at the CVS on 431 with the lifted DI with the SD rack?

Im up the road from you in Huntsville.

 

[Alabama Rover]

No, I can't say I have even seen a lifted D1 anywhere around here. I have seen a couple of D2's, 2 old Series, and 1 RRC

 

[amschnellsten]

there are a lot of bits that are interchangeable, take it from me. The seats will work but do require quite a bit of fabrication. I doubt the rear bins will fit due to the fact that the d2 is longer in the rear same goes for the headliner due to the length and the windshield height. If you headliner is bad one of the best fixes is to pull it, clean off the foam with a wire brush and paint it. It looks factory. The center switches, clocks, dash switched are all interchangeable. I have the center bank switches in mine and that is what controls my front fogs, rack fogs, and rear fogs. I have also installed the late d2 headlights and the rear tail light sections from a d2. Good luck!

 

[Mudy_ovl]

Tangent^2,

11b4v, I am in Huntsville too, actually Madison. I drive a Gold/Bronze DI, lifted with SD rack and Hella 4Ks. Alabama Rover, if you even venture this far north give us a heads up.

Back to your regularly scheduled discussion.

-Chris D.
Mudy_Ovl

 

[amschnellsten]

there is also a really cool switch combo in late range rover classics it is located on the driver side bottom of the center switch panel. It contains two arrows that are momentary and one in the center. I used it in my disco for in cab winch control. I will take a pic.

 

[Paul K]

Old thread, but will the cubby box lid from the console of an '03 D2 fit a '95 D1?

 

[best4x4]

D2 Parts that work on a D1:

Instrument Bezel & Dimmer Switch
Center Dash Bezel
Steering Column Cover
Indicator Stock
Wiper Stock
Center Console Lids
Glove Box
Driver Side Access Panel
Rearview Mirror
Sunvisors
Upper front Map Pocket Assembly
Sunroofs
Window Regulators
Window Motors
Door Seal Gaskets

 

[Paul K]

How about the fan speed controller (right side of the HVAC controls, slides horizontally 0123)?

 

[stu454]

Nope.