I'm sure many of you have done this. I had an incident where my airbox tube to the plenum got displaced due to torque - and was informed that this is probably due to a bad motor mount. So I purchased both mounts and am looking at the drivers side mount and wondering how best to replace it. Easy enough to remove the nut that is visible, but the other one is inaccessible, which leads me to think that i need to remove the entire bracket, which leads me to think that I need to remove the transmission lines, which leads me to think that maybe I should just leave it alone... !
Even if I got the other nut off - seems I would need to raise the engine quite a bit to get the mount out of there and a new one in.
What's the best way to do this?
Even if I got the other nut off - seems I would need to raise the engine quite a bit to get the mount out of there and a new one in.
What's the best way to do this?