Okay, I did the Sea Foam treatment, she smoked and ran like crap just like everybody else's seems to and just like my Tacoma did when I did that. However I now have an SES light on, not blinking. I'm guessing it's the O2 sensor although I have not had the codes read yet (truck has 70k with original 02 sensors). She runs fine, ran a little rough for a few miles, but once it cleared out she was quiet and smooth again. Should I just let it sit for a while and then try starting her up again to see if clears? I'm heading out on a 4,000 mile trip tomorrow, this was not in the plan