Hi-
Have been away, so I haven't visited these boards in a while- and I did a quick search
in the archives for this question with no results. or perhaps i didn't ask the search engine the correct question- so please forgive if this has been covered before........
Does anyone out there have any plans or drawings for a front and/or rear ARB/TMJ type bumper for my '95 Disco I? I have complete access to a fabrication shop with
mig/tig/plasma cutters/tubing benders, etc....... I have the time, ability, and enjoy this kind of stuff, so I thought I'd ask if anybody out there has done this before I start from ground zero. if I had one to look at, I could pretty much duplicate it- or make it better......
Any comments would be greatly appreciated. I know, the time it takes to make one, you could just buy one, etc- but that is not neary as much fun....
thanks-
Tim
Have been away, so I haven't visited these boards in a while- and I did a quick search
in the archives for this question with no results. or perhaps i didn't ask the search engine the correct question- so please forgive if this has been covered before........
Does anyone out there have any plans or drawings for a front and/or rear ARB/TMJ type bumper for my '95 Disco I? I have complete access to a fabrication shop with
mig/tig/plasma cutters/tubing benders, etc....... I have the time, ability, and enjoy this kind of stuff, so I thought I'd ask if anybody out there has done this before I start from ground zero. if I had one to look at, I could pretty much duplicate it- or make it better......
Any comments would be greatly appreciated. I know, the time it takes to make one, you could just buy one, etc- but that is not neary as much fun....
thanks-
Tim