DI LT230 transfer case

[RoverGrrl]

I own a '91 Range Rover and cracked the t-case in half last week due to my boyfriend's wonderful spotting. I would like to replace the BW viscous coupler with the LT230. I live in CT and am willing to drive anywhere reasonable to pick it up. I've been looking on Ebay and LRX, but haven't had much luck. Does anyone have one laying around? Thanks!

 

[D Chapman]

Will Tillery had some. He's in VA though....

 

[Sirfoss]

Will

Will Tillery had some. He's in VA though....

Dan is correct check with Will Tillery. 804-539-5845 make sure you get all the CDL linkage.E-brake components as they are different. And the coupling shaft...this is the shaft that comes out of the Transmission and goes into the transfer box The Borg is shorter splined and wont let the LT230 slide all the way on. Here is a picture of the two. The one on the left is from the Borg the other is for the LT230.
Mike

 

[Ron]

I have one here in Phila, but it does not have linkage, just the case. The earlier LT230s have the short input and will be fine with the existing output on your truck.

For you, if you pick up $300, 45k on it and I replaced the diff which blew with used.

Ron

 

[RoverGrrl]

Ron,

I'm interested. E-me off the web... LandRoverGrrl02@aol.com or you can call 203-887-2207. That's my cell phone. I work at a Land Rover dealer so getting the linkage wouldn't be a problem, it just would've been a little more helpful. Maybe arrange for a pick-up this week? Thank you! and also, thanks for the other guy...too bad VA is a long haul...