Anyone know the correct size bolt needed for the DII spring seats for the EAS conversion? I have searched, and will be using LR pt # 3578. Any help is appreciated. :victory:
This will be my 1st conversion, anyone out there done this? Those spring seats gotta bolt to something, correct? Lots of threads about wanting to do it or doing it, but no mention of the bolt size used to mount those seats...and no bolts come with the seats.:banghead:
If you are talking about the spring seats they are M10 X 1.5 X 30MM with M10 lock washers. The isolators are rubber and just sit on top of the coil spring.
Thanks, Mike. I should have left "isolator" out of the thread title, I was speaking of the spring seats. I am doing an air bag for spring swap, going w/ OME front 751 and 763 rear spring sets. Got the DII spring seats from a board member, no bolts included. Thanks to you, too, Pony Hater.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.