FREE stuff including a salisbury rear axle

[dave_lucas]

Free RRC SWb frame

Everything gone except the Frame.

No shipping or delivery, I do not have time to deal with shipping.

Located in Fort Collins CO

RRC SWB frame clean and rust free great for galvy or custom build. I think this will also work for a Disco I

 

[benlittle]

Uh... How much for the 3/16 plate shipped :rofl:

 

[EricCo]

I am in Loveland- How big is the workbench?

 

[JSQ]

Holy shit! Somebody get the free-fucking-sals!!!

 

[dave_lucas]

I am in Loveland- How big is the workbench?

Not huge, maybe 40? wide x 19? deep has a galvanized sheetmetal top on it.

Looks like this one without the drawers
http://www.hoslotcarracing.com/image/Tools/WorkBench.jpg

Holy shit! Somebody get the free-fucking-sals!!!

It is free for a reason, it is missing the shock mounts and is a bit rusty. Most of all I just want it out of my way. If someone can make use of it that would make me happy as I do not want to take it to the dump

Already took an entire load of stock axles, diffs, radius arms, trailing arms, drive shafts and other stuff this week just to get it out of here

 

[JSQ]

It is free for a reason, it is missing the shock mounts and is a bit rusty. Most of all I just want it out of my way. If someone can make use of it that would make me happy as I do not want to take it to the dump

Still worthwhile.

If I were in your neighborhood I would at least come pull the halfshafts out of it. I need a spare set of those.

 

[dave_lucas]

If no one comes to get it by this weekend I will pull them out for you prior to sending it to the dump. If you do not mind paying for the shipping.

 

[EricCo]

Let me know when is good for you and I will take the workbench off your hands... I would take the other stuff a well, but none of it works for my D1.

 

[JSQ]

If no one comes to get it by this weekend I will pull them out for you prior to sending it to the dump. If you do not mind paying for the shipping.

Of course not.
If you have the time that would be great.

Hopefully someone comes to get the whole thing. I'd rather lose the half-shafts than see the axle go to scrap.

 

[61rover]

I'll take the axle. Don't want to see that become bottle caps.

John

 

[dave_lucas]

Eric,

The workbench is yours. Send me an email and I will provide you with the address and time I will be there.

John,

Someone called dibs on the axle already but you are 2nd in line if he does not pick it up in time I will let you know.

 

[61rover]

No problem. Just let me know.

 

[Series1Rangie]

Dave, what condition is the hood in? Is it rusty, especially where the old range orver badge was mounted?

Thanks

Mike

 

[dunerv8]

I don't know much about Rovers. I am trying to put the fuel injection from a 1995 Land Rover 3.9 on the old Buick 215 v8. I need Mass air sensor, two O2 sensors, wire harness to the motor, cap, rotor, wires and Fuel Injection Fault Display from a 1994 / 1995 I think. Do you have and how much would you want for them. I am in Erie Co. Can you help?
Steve
dunerv8@gmail.com

 

[adriatic04]

alright man, you have brought back every old part out thread to date. check the dates on these things before you post.