Hood Blackout

[Zonkatruck]

How do you remove the nozzles? I have the heat shield attached under the hood and was trying to get an idea if there are clips to depress to release the nozzle base from the hood.

How hard is it to install the decal yourself or is it one of those don't even try?

Thanks!
Zonk:toetap:

 

[post]

How hard is it to install the decal yourself or is it one of those don't even try?

Thanks!
Zonk:toetap:

easy...use soap and water on the hood and decal, then move where you want it and then use a squeegie to push the air bubbles out.

 

[rmuller]

The nozzles are attached by clips and come out easily.. only problem is, over the years they may become brittle... I had to replace one of mine..

Here are instructions on how to do the hood blackout:

http://www.viggdesigns.com/gallery/LandRover/roverhoodinstall

 

[Zonkatruck]

Sounds easy enough- did you have to remove the black insulation piece to get to the nozzle clips?

 

[rmuller]

Nope, didnt have to remove it..