Lockers, Axles, CV's and Swampers

[Buddy]

Sold

 

[K-rover]

Wait.. so now what are your plans?

 

[Maximumwarp]

Wait.. so now what are your plans?

Lowered on 20's

 

[DiscoPhoto]

How much for the front shafts?

 

[Devildog01]

Zack, always wanting more shaft.

 

[DiscoPhoto]

<3

 

[Buddy]

How much for the front shafts?

$3,100 and you'll get two lockers and CV's for free.

 

[Buddy]

Wait.. so now what are your plans?

Top secret project. But Taylor is pretty close.

 

[Lsmyth26]

pmd

 

[fishEH]

Top secret project. But Taylor is pretty close.

A rat rod, sweet.

 

[K-rover]

Top secret project. But Taylor is pretty close.

 

[Buddy]

Lockers:

 

[Buddy]

Axles & CV's"

 

[Buddy]

Tires:

 

[bri]

No way to run thos stealth? I.e. alum wheels?

 

[Buddy]

No way to run thos stealth? I.e. alum wheels?

I assume you're asking about the tires? Yes they will work on 16" aluminum wheels. Spec on them is between 6.5"- 8" wide wheels.

 

[Nomar]

I think bri is referring to those blingy flanges...will they fit under aluminium wheels??


.

 

[bri]

Correct. I think I ran those flanges on the front of my D1, but had to use steel wheels so the cover could make it through the wheel.


They may have made it through the alum wheels, but looked dorkish... can't remember.

 

[Buddy]

I think bri is referring to those blingy flanges...will they fit under aluminium wheels??


.

I'm pretty sure I've run these under the stock '95 wheels, I've also seen lots of other trucks run stock wheels with HD axles, and there is no mention on any of the product websites that says they won't. So I'm going to go with they should.

 

[Buddy]

Correct. I think I ran those flanges on the front of my D1, but had to use steel wheels so the cover could make it through the wheel.


They may have made it through the alum wheels, but looked dorkish... can't remember.

Did you run the larger 110 flanges with AEU2522 CV's those are the only ones I can see sticking out of the aluminum wheels. There are the later short versions. They do not stick out any further than the stock flange with rubber cover, they are just hardened steel with more spline engagement.