M.A.F. sensor wires?????

[Chaodic1]

Looking to find where wire #5 on the plug for the maf go's? Have back probed each wire and got good values except#5 !
Have looked and read alot of the Rave manual and the electrical dictionary, but can't find exactly where it ends up. What I'd like to do is to run a new wire direct being can't find the brake in the wire. Plz help
Pics would help alot

 

[WaltNYC]

what model year? D1 or D2? Best to put it in your signature. (look for "UserCP")

Here's is the diagram from a '97 D1.

 

[Chaodic1]

2000 D2 v8 sorry thought I put all information in my profile but didn't think of in my signature good looking out. Anyways wanted to run a new wire direct to computer if that's where it ends up?

 

[Chaodic1]

Is this image same for D2? Don't resemble what's in the rave. Just look for clarification on where the wire leads to so I'm not just taking a stab at what I think it might be and b wrong and fry something.

 

[mbrummal]

it goes to pin 23 of connector C0636

of the ECU.

(^^^that comes from the Electrical Circuit Diagrams for the D2 in the RAVE manual. The Electrical Library will show you a picture of the connector and the Workshop manual has a chart of the connector pins and functions.)

That is the middle connector (of 5) of the ECU

The original wire is .5 mm^2 so a 24AWG wire should be ok to replace it.

 

[Chaodic1]

Thanks much will take a look in the morning... And thanks for the timely response much appreciated

 

[Chaodic1]

So, ran new wire and has voltage!! Yay... But it's reading battery voltage shouldn't it be .0 to 5.0 volts? Checked resistance before I ran new wire and had none from wire at ECU up to maf so definitely had a break in it. Just wondering if it's reading correctly any thoughts...

 

[number9]

Just wondering if it's reading correctly any thoughts...

23 MAF sensor signal Input, signal Analogue 0-5V

Doesn't seem like it should be batt vdc.
......

 

[Chaodic1]

Quadruple checked that I was on correct pin and correct plug. Seems to run good but haven't been able to watch real time values yet being my Bluetooth reader has stopped working