New OME 762 Springs - One HIGH Corner

[t42beal13t]

I just wrapped up installing new OME 751 and 762 springs. Three corners look great but the rear left corner, with spring marked 762A, is sitting a good two inches higher than the others. I triple checked that the spring was seated properly and I can't find any reason for this corner to be sitting so high. Any insight?

 

[helievacpilot]

Who did you get them from? IF your installation is correct, sounds like they may have sent you the wrong spring. Most reputable sellers will swap it out for you.

 

[t42beal13t]

They shipped directly from OME.

 

[helievacpilot]

Call 'em up and see what they say.

 

[t42beal13t]

I took out the spring and reinstalled it with no change. I'll call ARB in the morning.

 

[KyleT]

We're they the same height on the ground?

 

[t42beal13t]

I didn't measure them but they were close enough that nothing stood out when looking at them.

 

[crash]

Are they not designated left or right side? I seem to recall they have a tag on them marked A or B.

Crash

 

[KyleT]

Are they not designated left or right side? I seem to recall they have a tag on them marked A or B.

Crash

Yes drivers side is A on the old ones. I think the new ones says ds and ps. But I xant remember if all of them ar that way, I seem to remember some are not handed.

 

[t42beal13t]

I have A on left, B on right. I'm going to swap sides today and see if it changes anything.

 

[p m]

Have you figured it out yet?

 

[t42beal13t]

Have you figured it out yet?

I swapped sides and it raised one side up a bit making it look closer. They're close enough now that I'm satisfied.

 

[p m]

Do you have the rear sway bar? If you do, take a peek - the links between the axle and the sway bar must both be hanging down from the axle.

 

[t42beal13t]

No sway bars.