Now parting: 1996 Discovery
- Thread starter crown14
- Start date
The seats (near mint) were snapped up early. I am getting some in exchange on a core type basis, but they are probably as bad as what you already have.
I was drunk when I said I would take the sliders....I still want them though its just that I like to wait until Im good and hammered before I make any serious decisions.
B
bdenny
Guest
From the front seats forward this truck was pretty much intact and near perfect. Console, dash, etc. Behind that, everything was removed a couple years ago and has been stored indoors so all that is quite nice too. No rear loadspace cover, but let me know if you need anything else interiorwise.
Would you consider separating the shift placard from the center console? I need that to make the D1 shifter install look complete.
Front driver's side brake lines, the hard one that goes to the caliper and the soft one upstream from that. I dont know if it would be too much $$ to ship to central VA but i need a rear bumper too. also the little springs for the brake pads. Lug nuts? Maybe two or three? And a pass side front turn signal and pass side front bumper end cap with running light/lens. I think thats all for now..
Sorry to whoever asked earlier, had to clear my PM box again- the truck has 111k on it, the engine runs perfect, the transmission shifts perfect, and the transfercase works perfect as well (but is missing the linkage).
Wow. Really missed the boat on this. Still doesn't hurt to ask... Any chance you still have the SRS ECU (sits inside the center console)? Preferably with no codes on-board so I can save a trip to the dealer.