Hey folks, just had the front prop shaft from my 01 D2 rebuilt using spicer u/joints. In talking with the shop folks at Oliver's Drive Shaft Shop they the front drive shafts often have water getting into the seal where the male and female ends meet causing corrosion. This water often comes from the A/C condensate while the vehicle is sitting still. This along with the heat from the CAT causes issues it seems with the front props.
So anywho, now I am trying to reinstall this front prop and after bolting it up to the TC I can not get the shaft to extend out so that I can bolt it up to the diff. Any suggestions? I have tried tapping on the front yoke with the handy dandy ball peen, but not luck. :banghead:
Thanks!!!
Rowdy
So anywho, now I am trying to reinstall this front prop and after bolting it up to the TC I can not get the shaft to extend out so that I can bolt it up to the diff. Any suggestions? I have tried tapping on the front yoke with the handy dandy ball peen, but not luck. :banghead:
Thanks!!!
Rowdy