Well, there was one negative outcome from yesterdays off road test run. See the attached photo. When I purchased this D1 the rear sway bar had already been removed.
The springs are one of the few things in the suspension I haven’t removed/installed. I am also pretty sure this D1 was worked on by high school auto shop students. The owner previous to the one I purchased from was an auto shop teacher. It is the same one that had the axle shaft seals installed backwards as well as some other started and not completed work on the suspension. The owner I purchased from didn’t do much more than hold onto it and lost interest.
What are the solutions to keep this from happening again?
The springs are one of the few things in the suspension I haven’t removed/installed. I am also pretty sure this D1 was worked on by high school auto shop students. The owner previous to the one I purchased from was an auto shop teacher. It is the same one that had the axle shaft seals installed backwards as well as some other started and not completed work on the suspension. The owner I purchased from didn’t do much more than hold onto it and lost interest.
What are the solutions to keep this from happening again?
Last edited: