Safari Gard bumper fits RRC or D1. Only damage is a bend in the skid plate as seen in pictures (left just inside the wheel). Located in Portland, OR. email jahmann@hotmail.com or call 503 750 8965. $600 obo.
RRC/D1 Safari Gard Bumper
- Thread starter jahmann
- Start date
Not sure about shipping, but I assume it will be quite a bit. Maybe someone else can chime in who's had a bumper shipped recently. I'll try and get a picture of the dent today. It is about a 3" long section of the skid plate that is rolled over the metal support that holds it in place.
Put in on the Big Dog bus. I shipped mine from Athens, Ga. to Wash. DC for $100 flat and didn't have to palletize it either.
Dave, How's it working out for you? I kinda miss it, the bumper not the winch. I'm digging the new Ramsey.
Are you going to URE ?
Are you going to URE ?
Ren Ching said:
So far so good. bent the skid plate pretty badly at the ROAV summer event. Nothing that taking it off and running it over own't fix. 
I think I bent one of the long wraparound sides of the bumper too. And the recovery eyes on the front are like two prongs that stick into the face of some steep banks I have tried to climb. If i had to redesign that bumper I would fix those. Larger tires would help. I'm running the 245/75 MTRs that came with the car. Even 235/85s would be a step up. Or some longer springs.
Winch is on the floor of my shed.
Going to try to hit URE. I'll look for you there if I do.
I think I bent one of the long wraparound sides of the bumper too. And the recovery eyes on the front are like two prongs that stick into the face of some steep banks I have tried to climb. If i had to redesign that bumper I would fix those. Larger tires would help. I'm running the 245/75 MTRs that came with the car. Even 235/85s would be a step up. Or some longer springs.
Winch is on the floor of my shed.
Going to try to hit URE. I'll look for you there if I do.
DennyDoler said:
