so i need some help figuring out where one of the vacuum lines on my d2 goes. was hoping someone had a pic of the area of the driverside firewall they could post up. it is a non sai unit.
thanks!
thanks!
vacuum lines d2
- Thread starter AGH Sasquatch
- Start date
Are you talking about the plastic breather runs parallel to the brake lines? It doesn't connect to anything.
no, there is one that comes out of the fender right there close to the fire wall. it is looped to go over or under the master cylinder. cant figure out where the hell it goes. i saw the one you are talking about and wondered about it for a minute too til i figured out it was a breather.
I'm not seeing what you are talking about. The only thing I see is the hood cable, throttle cable, and and wires for the heated windscreen. Can you post a picture?
The only one I see running there is the brake servo line, connected to the brake servo on the one end and the inlet manifold plenum on the other end with the red plastic thingy. It runs between the brake servo and the heat shield on the brake servo, then below the master cylinder and into the brake servo.
That's it! Almost... I best it is for his windshield washer jet. It goes into an elbow that is also one of the plastic clips that hold up the mat under the hood. I should have known, someone just asked me about that a couple weeks ago.