Hey guys finally got the oil pan and oil pick-up gaskets to arrived so I am starting to reassmle the beast....however, one quick question. I did not remove the cam and lifters so when I go to install the push rods and valve rockers am I going to have to perform any valve adjustments like on the old chevrolet's..... I dont think so since it does not look like there is any way to make adjustments.... Just would like someone to clairify thanks in advance....... Matt
Valve Adjustment Needed??!?!
- Thread starter RamRod
- Start date
RamRod said:
Make sure the oil passage way in the rockers and rocker tubes are clear of all sludge. I don't know what your main reasn for removing the valve rocker assembly, but this is a good time to make sure all oil passage in the valve train is clear.
I was actually doing head gaskets... The oil Pan was just removed as a by product so I could make sure all the oil passanges were clean
But everything Is done.... Got it reassm. last night and it damn runs like a top so I was really really excited
But everything Is done.... Got it reassm. last night and it damn runs like a top so I was really really excited