Well crap need an exhaust

[ZONE ZERO]

I had the 92 RRC on the lift yesterday and I need a new exhaust from the flange in front of the muffler (closest to the engine) to the rear .
I had to cut everything out, in reality that ment cutting the only hanger holding anything up.
Where can I buy a good my cheap exhaust.?
I'm not having much luck on google everything I find is 500 and up

 

[Nomar]

My local shop built mine from the flange back to the bumper with a Flowmaster something-or-other for less than $200.


.

 

[Roving Beetle]

Used one is all you're going to find for less. Or local shop using a flowmaster or magnaflow (I'd recommend a magnaflow)

Save you're flange if it's usable and have a shop weld from there back.

 

[azarmadillo]

I installed the Flowmaster Y Pipe last time. Hate it. Fit like crap. Eventually I had the junction between the Y pipe and the muffler cut out and a solid pipe welded in. And after two years the catalytic converters are almost dead. I barely passed emissions.

 

[ZONE ZERO]

3 shops today best they could do was 550$ I think. That's crap I'm going to order a muffler and have a pipe bent on my own
Anyone recommend a muffler. I was thinking a 40 flow master .

 

[azarmadillo]

I have an NRP Y Pipe that would fit but it's here in Phoenix. Find it a rideshare on Craigslist. I'd sell it for $200.

 

[Roving Beetle]

Skip the flowmaster. Get a magnaflow - they breath better. The flowmaster sound nice but hold a lot of heat under the truck and bake the floor pan/rear carpet badly.

 

[Nomar]

I've not had any heat issues with the Flowmaster.
But get the 50 or 70 series unless you like droning at certain rpms.

 

[ZONE ZERO]

Well I got a flowmaster for 50$ brand new, so I'm going to make it work, I can't afford to spend to much on this right now finishing up school getting married and general life stuff making more work for me than I'd like at the moment.
how bad can the noise be in the cab I've been driving with just the down pipe. It's more the fumes that are getting to me. I have the old pipe to use as a reference to bend up something better I'm good with a welder so I think I'll give it a go.

 

[ZONE ZERO]

I picked up the 10 series flow master, it's small light and the install was easy, took me about 2 hours to do all welded in with good hangers.
It's not that loud at all I had one in a jeep cherokee that drove me nuts. This is just a nice rumble at the back of the RR
Price for everything I needed was just at 98.55$