Where are the "continuity tests" described?

[DeanBrown3D]

Keep seeing them on the Diagnostic code descriptions for earlier discos.

E.g.

Code 14 - Coolant sensor
Usually indicates a bad fuel injection coolant sensor. May also indicate a bad engine thermostat or a stuck viscous fan clutch. Refer to test 14, continuity test procedure.

Thanks very much,

Dean

 

[Kyle]

Most of those component tests are generic tests Dean....

Kyle

 

[p m]

Dean, that means you need to measure the resistance of the sensor at the ECU connector - to make sure both the sensor and the wiring to the sensor are okay. Haynes manuals for RRC and D1 (3.9) describe this procedure in great detail.

 

[Kyle]

All of them are pin out tests and not component tests ? Thats nice if you have the pin out assignments but if not you are fucked..

Kyle

 

[DeanBrown3D]

Haynes manual? Ok I'll have a second check. Kyle - so they are generic, I still need to know the test procedures, resistance and/or electrical properties of these things. I have a whole load of things on the D1 that could be bad and I dont want to replace them all at $150 a go each.

-D

 

[Kyle]

Meaning , it should be simple enough to find the parameters on the net for anything close and go from that.


Kyle

 

[p m]

try rangerovers.net

 

[sven]

Dean,
Is this what you're looking for?