Wiring Issues 95RRC

S

ssavas

Active member
Mar 8, 2010
31
0
Franklin
I can not figure out the wiring for the coil on my 95 RRC. Here are the details

3.9 with Mallory Unilite and Bosch coil. I am getting no spark from the coil to the discs. I have the two black and whits wires that run through resistors to a single black and white wire attached to the coil negative. I have the single white and green wire running to the mallory Ign ballast on the same side as the red wire to the distributor. The brown ground wire is to the block and the blue negative runs to the coil negative post. I am not getting any readings for test two V2,V3 and V4. It seems that I am missing power to the coil but i am not sure where I went wrong...

Stephen
 
carlosz

carlosz

Well-known member
Apr 20, 2004
581
0
Annandale,Va
some 5 yrs ago I installed a mallory unit in a 96 d1 , there is an extra wire you can run for emergency cut off or to a rev limiter but the instructions do not tell you about it (their tech line told me about it).
in any chance you may have grounded this wire thus overiding the power. I want to say it was the green wire, I may be wrong about the color but not about function.
good luck.
 
You must log in or register to reply here.
Top Bottom