Wiring my full new harness. Is the speedo pulse wire a green one?

[Roving Beetle]

Using a 1998 disco 1 lt230 in the RRC/TDI swap with a new complete custom harness and aftermarket gauges etc.

The sensor plug at the transfer has two wires, if I recall they are one black and one green. Going on memory from earlier today. One should be 12v input and the other is pulse effect out. Does anyone have easy access to a diagram or know FOR SURE which is which?

Some have a three wire - with ground - this later disco doesn't. Three spots on the plug, middle wire is blank.

Thanks!

Doug

 

[kk88rrc]

I don't know FOR SURE… but a quick google says BR is signal.
"the GY wire on the transducer is 12v and the BR wire is the pulse."
http://www.defendersource.com/forum/printthread.php?t=15253&pp=40
http://www.roverlanders.bc.ca/roverforum/viewtopic.php?f=5&t=6968

 

[Roving Beetle]

Thanks Kevin.

I had done a quick search on the web with the iPhone but got frustrated quickly. Ha ha.

Cheers!

PS - how about those switches and harness?

 

[kk88rrc]

I'll try my best to pull them this week before I leave again. Thought you needed the housing & harnesses not the switches.

 

[Roving Beetle]

Correct. I need the housing and harness from the switch down under the seats etc as much as possible.
Both sides.
Thank you!