| Author |
Message |
    
Arthur
| | Posted on Wednesday, April 10, 2002 - 12:30 pm: | 
|
I have a 96 Disco and am getting a "Airgap to large" error code. (this information cost $180 at the local LR dealer). They seemed to feel the entire front wheel needs to be dissasembled to diganose this problem. At $90/hr with no hard estimate I decided to look at this first.
What I found was that the sensor is not fully seated in the housing on this side as compared to the other. I removed the sensor, cleaned off corrosion that had built up on it and re-installed. As the sensor just slides in a bushing it stopped about 5 mm short of the shoulder on the sensor.
I'm suspecting that the bushing should be replaced. It sits in the upper swivil pin. My question is can the upper swivil pin be removed to gain access to the sensor bushing without having to take the anything else apart. I'm also wondering if this is the correct course of action.
Any comments would be most appreciated. |
|
Closed: New threads not accepted on this page