| Author |
Message |
    
Kyle Beckman (Kbeckman)
| | Posted on Saturday, September 14, 2002 - 01:07 pm: | 
|
Does anyone have a picture of the detent spring / grub screw on a D2? I'm trying to put in the solenoid CDL from GBR and directions say to remove the detent spring, but I'm not sure where it is. |
Al Oliveira (Offroaddisco)
| | Posted on Saturday, September 14, 2002 - 01:24 pm: |
|
hmmm... not sure. I did the D1 linkage myself. In that setup I don't ever remember a spring of any kind. Where in the setup are you? Maybe the directions are talking about a spring on the solenoid? |
Kyle Beckman (Kbeckman)
| | Posted on Saturday, September 14, 2002 - 01:58 pm: |
|
Al,
This is what the instructions say:
"Energize the solenoid, the lever bolt should now fit through the rose joint and Diff Lock lever. There must be free movement of the in-line swivel when the system is energized. Remove the detent spring. This is no longer required. The solenoid holds at 150N, 3 times the holding force of the detent ....."
The only other info I found concerning the grub screw/spring was at ../17/427.html"#444444"> |
Paul D. Morgan (V22guy)
| | Posted on Saturday, September 14, 2002 - 02:03 pm: |
|
Kyle,
If I am reading this correctly, I think GBR instructions are referring to the solenoid itself. Remember, a detent spring does not have to resemble a coil form, detent srpings can come in linear or as a Push - Pull perpendicular type. If I had a picture of your solenoid I could show you.
I'll check back in a few hours........ |
Kyle Beckman (Kbeckman)
| | Posted on Saturday, September 14, 2002 - 02:20 pm: |
|
Paul,
Look at the link in my previous post. It looks like it is on the front output housing somewhere. After reading the thread for that link, I'm still not 100% sure.
Kyle |
Ron
| | Posted on Saturday, September 14, 2002 - 04:34 pm: |
|
On the front output housing there is an allen keyed grub screw on the flat part near the warning switch and the 3 bolt diff lock cover plate/ Remove the grub screw and it will reveal the detent spring and ball.
Ron |
Paul D. Morgan (V22guy)
| | Posted on Saturday, September 14, 2002 - 06:14 pm: |
|
Well, Is that it? The suspense is killing me. |
Kyle Beckman (Kbeckman)
| | Posted on Saturday, September 14, 2002 - 06:19 pm: |
|
Yeah, that's it. Ron is correct. I couldn't find it before because it was caked with dirt.
Ron- Many thanks. Do you have any idea what size allen wrench for that thing?
Kyle |
|
Closed: New threads not accepted on this page