SG 3-link install
- Thread starter Jake1996D1
- Start date
mgreenspan said:
Similar to to a Mog suspension, looks a little under built for driving on road and kinda sketchy. Looks great if you spend all day on the RTI and drive it back on the trailer.
^x2 on what denny said.
then again, denny I never thought about copying a 404's set up.....I'd have to have a couple beers in me before I drove it at highway speeds back home though.
then again, denny I never thought about copying a 404's set up.....I'd have to have a couple beers in me before I drove it at highway speeds back home though.
I like the picture of the truck on it's side ha!!!
It does make for one sweet turning radius though
It does make for one sweet turning radius though
Mongo said:
Yea no doubt they need to make a bigger disclaimer.. Maybe for a truck that never goes over 10 MPH.. I love that the first example truck has like 16" air shocks
ptschram
Well-known member
DennyDoler said:
There is no reason you can't use those, I have the same vintage knuckles on my SWB trail rig. If your calipers use the smaller bolt, drill them out. Otherwise, just torque them in place and you'll be fine.
i bet the AS is super high on that one link.
Frank, did Ballfab improve the bushing rubber in that bushing? Mine lasted about 5 miles then had about 1/4" of play.
Frank, did Ballfab improve the bushing rubber in that bushing? Mine lasted about 5 miles then had about 1/4" of play.
yes...if the bushing you have are red, they are shit. The blacks are from a different manufacturer. I have the blacks in my pos and they are still going strong after 2500 miles. It doesn't sound like much, but that's a shit load of miles for the d2
I'd love to wash that 1 link thru a calculator and see just how bad it is.
I'd love to wash that 1 link thru a calculator and see just how bad it is.
mine are/were grey. not black. the center hole that the center sleeve slid into was also a hexagon, kinda wierd.
KyleT said:
I think they are all a hexagon, mine is and is black. I think I need an orbital my jam nut came loose this past weekend..
Mongo said:
The nut doesn't stay tight cause it rotates side to side. Unless I'm an idiot I thought that nut should be tight at all times.