Recent content by rufus

...all it is getting on codes so far is random misfire? Anymore ideas?

nah...the fuel door was closed. I drove for 100 miles or so with it off. Like I said, fuel it back up, capped it and pressurized the system. Just wondering if I threw some thing off. The Disco is finicky at best, so I am digging. Can't get a scanner for a couple of days. --- anyone in...

...anything to do with having left the fuel cap off?

beats me. I originally thought it was because it was low on fuel and the gas cap was left off. But I fueled it up, cycled the pump and few times and pressurized the tank. I can't find squat. out to get a scanner. I am sure it will show miss fire/etc and not the issue.

Yeah, I realize you can't adjust it. I just figured the two things that have a hand in injection and timing are the cam and crank sensors. I a green on these... the VSS will cause it not to run? Thanks all...I'll post back soon. Fortunately it is 40 degrees and pouring rain!! SWEEEET!

I'll get to it in the morning...thanks for any and all input.

Ran fine for quite some time afterwards. Later on, it began to idle rough...then badly...then, not run at all. When it does "run" it stumbles badly, misses all over, and coughs through the intake (bad timing?). What can I check? Cam position sensor, crank sensor? All the intake areas looks...

Sold.

Sale pending.

2003 Land Rover Discovery 67,000 miles, power everything, quick and nimble on it?s feet, extremely well taken care of one owner vehicle, all services current, title in hand clear and ready for its new owner, never abused, never off roaded and exceptionally clean, please call 512-554-1544 (we're...

I need to replace the door handle on the rear hatch... what is the best way to pull off the inner trim panel with out snapping off all the clips? Thanks for the input and all help is appreciated.

For sale: New, never even been taken out of the shipping box: Ignition Switch for a 1997 Disco. Will fit rover classic and '95 up series I Disco. $95 Shipped.

The whole truck dies when I unplug the switch. I have been chasing my tail here. I just tested the voltage to the small wire going to starter (solidoid switch wire) and it's cold when it needs to be and momentarily hot when the key is turned to start. If it were constant on the switch would...

TOP... I need help with this pronto if anyone has the time to look this up or is knows enough to help. Could it be the starter?