Recent content by thejaw77

  1. T

    Death Wobble - '04 DII

    Are the rims the original one? I once had a 99 Range Rover that a previous owner had put 20" rims on from I think a newer model disco or range rover. Anyway they were a larger size than the stock rims and caused severe death wobble at speeds near 50-55mph. This was caused by the owner never...
  2. T

    P1316, P0304

    96 Discovery SD, Altia Silver, 4.0 V8, 93000 miles...When I pulled all plugs this weekend they are all buring the same except #4. This plug is fouled with carbon and has a slight hint of oil....slight. Dry compression is low at 135psi. Wet compression is 170psi. If correct, my piston ring is...
  3. T

    Help me diagnose this... P1316....

    I'm getting the same code! Have you figured this out?
  4. T

    P1316, P0304

    I am getting a P1316 (misfire causing excessive emmisions) and a P0304. The battery is good and I'm getting spark. New coil packs. I'm running champion copper spark plugs and 8mm kingsbourne wires. Compression checks out ok. New fuel injectors, fuel filter, and fuel pump. I have tried +4 spark...
  5. T

    Doesn't re-start when hot

    Do you have coil packs or distributor?
  6. T

    Doesn't re-start when hot

    Does it crank slow? Is there a clicking sound when you try to start it? Bad starter?
  7. T

    Doesn't re-start when hot

    The fuel pump may still come on, but may be weak. Do you get misfire at highway speed? Does it lose power, then regain power when you press the accelerator? Does it have trouble climbing hills? Fuel pump failing symptoms....misfire, delayed acceleration, vehicle won't start, runs...
  8. T

    Doesn't re-start when hot

    Does the vehicle stall or shut down without warning during operation? Or does it not restart after primary operation? Do you have a CEL?
  9. T

    What does a timing chain sound like when it breaks?

    You will notice a rattling noise underneath your vehicle's hood when you start it. If the chain is loose, you may hear a loud, knocking sound from the engine. It may backfire or misfire.
  10. T

    Doesn't re-start when hot

    Also, if the pumps filtering mechanism get clogged with impurities the engine will show signs of rough firing. Injectors need constant pressure. If fuel isn't pumped constantly and smoothly signs of hesitant start and stumbling problem on ignition will be the result.
  11. T

    Doesn't re-start when hot

    Are you actually getting misfire codes or does it just feel like misfiring? When you turn the ignition to position 2 can you hear the fuel pump turn on? It will be a quite humming or buzzing sound coming from the rear when your in the cabin of the vehicle. If you don't hear anything when...
  12. T

    1998 DI: CEL, P0300, P1316, misfiring / running rough (long)

    I am getting the same codes (1316, 0304). How did you know it was the coil packs? I'm running new kingsborne 8mm wires and champion copper plugs. Also installed all new coil packs. Though they are not genuine. When I unplug the MAF and clear the codes they don't come back. Any thoughts?
  13. T

    Engine coolant temperature gauge reading 3/4 hot

    I have since gone back to champion coppers for the fatter spark. I have a genuine temp sender (Part#1425) unit on order from Rovahfarm. Anyone cure the P1316 misfire? I've been chasing this misfire for a 1 1/2 years now.
  14. T

    Engine coolant temperature gauge reading 3/4 hot

    When I did the compression test I think what I got was 140...it was about 8 months ago. What about a partially clogged converter? I am getting spark and everything. I just wonder if the engine ecu is faulty. What would throw off the ignition timing?
  15. T

    Engine coolant temperature gauge reading 3/4 hot

    The pressure test was for the cooling system. I did a compression test awile back and all the cylinders where uniform. I would like to do another compression test though since its been some time and components have been replaced. Is there an easy way to deal with a stuck valve?