Thanks rovercanus. I figured as much but never clarified with RTE before ordering. As I said above I never actually had the chance to install as the truck died shortly after purchase. Here is the actual link to the kit although mine has the larger spacers to make it a 5 inch lift...
Hello.
I have a full RTE 5" lift for an 03-04 Disco. Never installed in original crate.
Includes:
RR4-3P Progressive 3" front coil
RR1-3 Rear Spring
BLS2F Front Series II Brake Lines
BLS2R Rear Series II Brake Lines
RSR Rear Upper and Lower Spring Retainer Set
PHDEX Adjustable Panhard...
03-04 kit. Never installed. Still in original crate.
http://www.rte-fab.com/products?page=shop.product_details&flypage=yagendoo_VaMazing_zoom1.tpl&product_id=77&category_id=13
Located in Western Canada. Will ship. Open to offers.
Cheers...
Ditto here. I suffer the same sound. Noticed my daytime running lights stopped working around the same time. Always thought it may be a relay or the fuse box doing it.
If you figure it out please post the solution.
Cheers.
Looking to replace a cracked dash center fascia with a new replacement. Microcat lists my current fascia as AWR1383PUY. I can find AWR1383LNF replacements but they are listed as Ash Grey. The pictures seem to indicate that the Ash Grey looks identical to my black (PUY) part number. Does anyone...
Thanks Greatdivide1,
I wasn't aware a RRC rear shaft was an option. I'll have to do a some searching regarding the swap.
You have any pics with your 5inch lift installed?
Are you running the RTE 4 inch with 2 inch spacers rear and 1 inch front?
Yes. Unfortunately I am told that this product can not be shipped to my address here in Canada through Amazon.com.
I think a road trip to the border may be in order!
Yes. Already tried and waiting for a response.
And yes have Amazon'd it. Canadian sellers want $60 for a 16OZ bottle. Obviously it's hard to get here and someone is making a fortune. American retailers will not ship here. I've tried to purchase from everyone I can find, ebay/amazon and...
Thanks for the responses guys. I currently have a Tom Woods Double Cardan in the front. Rear is stock. I'll install the lift and see what it looks like at that point. First on the post lift priority list will be a TW DC rear shaft.
Take care...
Check the throttle body heater. I just had mine let go and start slowly dripping coolant onto my valve cover. Took a couple of months to drain the system to the point I was over heating. Did some searching and found a very slow leak off the bottom of the throttle body.
If you don't know where...
Anyone out there running close to a 5 inch lift on a D2?
I'm looking for length measurements, pinion angles for the front and rear driveshafts. I don't have my lift yet it's on order from RTE. I've ordered the RTE 4 inch lift with 1 inch spacers. Looking to pick up the props and have them in...
Ended up ordering the OEM Tails straight from the dealer. Were cheaper than the AB BritPart replacements. Go figure.
I also ordered clear side turn signals. I ordered OEM Freelander markers as apparently they are a direct fit for D2 markers and are clear.
My rear drivers side door and cargo door both crapped out over the holidays. Time to order new actuators and pull the door panels.
Doesn't seem to hard, just time consuming to do it right.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.