Search results

  1. STLGrrover

    Mounting auxilliary reverse lights on a D2

    Nice write up. I recently installed these same lights but rack mounted them. I also found a nice spot for the switch between the mirror controls and steering wheel.
  2. STLGrrover

    NGK Iridiums?

    Thanks for the replies guys. I'll probably go ahead and give them a try.
  3. STLGrrover

    NGK Iridiums?

    I'm not currently running them, but was intrigued and curious how long they are lasting and if there is really a reduction in carbon buildup or fouling compared to coppers and platinums. I started getting some intermittent misfires on startup a couple of weeks ago, and was thinking I'm probably...
  4. STLGrrover

    NGK Iridiums?

    For you guys running the NGK Iridiums, are you still satisfied with them?
  5. STLGrrover

    Tell me about Independence/Kansas City MO

    Haven't made it to either one of these places yet, but have heard pretty decent things about Kansas Rocks. The other one is brand new, haven't heard anything about it at all. http://www.ksrockspark.com/ https://www.facebook.com/CentralMOOffRoad
  6. STLGrrover

    Midwest Land Rover Rally. May 16-18

    Yes, good trails, great people and no damage this year. It was a good time.
  7. STLGrrover

    D2 Steelies

    Are they 16"? Can you give me the rim width and did they come with the steel lugnuts or caps? Thanks
  8. STLGrrover

    2000 D2. So clean!

    Looks nice and I would be tempted, but I really need a smaller, high mpg car for a daily driver right now. Have you thought about bringing it out to the meeting tonight? There's been some newer guys showing up lately, might get some interest there.
  9. STLGrrover

    IM incomplete - any tricks up the sleeve?

    I'm not sure on the D1s, but on my D2 I had to let the fuel level get below 1/2 tank to reset the evap monitor.
  10. STLGrrover

    D2 Rear Bumper light bulb holder and gasket

    PM sent. Thanks
  11. STLGrrover

    D2 Rear Bumper light bulb holder and gasket

    Looking for 2 each of the D2 rear bumper light bulb holders and gaskets/seals. I don't need the lenses or housings, just the holders and seals. Thanks, Darrick
  12. STLGrrover

    Where in the world is Denny D?

    I ordered my rear bumper from him mid-August and haven't been able to get ahold of him since the beginning of Oct. I guess my 3 month wait so far isn't to bad. It would be nice to get a response from him though. Darrick
  13. STLGrrover

    Doing ok. Haven't heard anything from you in awhile.

    Doing ok. Haven't heard anything from you in awhile.
  14. STLGrrover

    Paging Denny Doler, Hard Labor Creek Fabrication

    Did the OP ever get in touch with Denny?
  15. STLGrrover

    Under armor suggestions?

    Tactical Rover/4x4 diff guards Damn....one could have confidence and all day protection with those wings. :D Couldn't help it. I'm sure they are great. My QT's have taken quite a few shots and are still holding up well.
  16. STLGrrover

    Bullshit Land Rover Ladder

    I bought my rack and ladder from them about 2 1/2 years ago. The ladder seems to be fine, no sign of any rust at all. But, I have found a couple of small spots on the rack that I'll have to take care of sooner than later, nothing major. Hope this helps, Darrick
  17. STLGrrover

    Fine "vapor" blowing out of the vents when blower is off

    Don't forget the milk the other nipple on the drivers side. It's right above the transmission shift linkage......and a bit harder to get to.
  18. STLGrrover

    Need boat ideas for putting on roof

    yeah, that's what I thought too
  19. STLGrrover

    Need boat ideas for putting on roof

    Here you go :D http://stornboat.com/ Actually, I'm not sure if there will be many options for what you are looking for, 1 boat, 4 people and you can still get it on your roof. 4 yrs ago I bought a 15ft inflatable tandem kayak for myself and 2 kids. Problem was the kids kept growing and I...