Search results

Hello, 2000 DII here. 160,000 miles. Replaced the throttle body gasket a week ago. Lots of coolant under car when I parked after arriving home today. No increase on temperature gauge. Expansion tank almost empty. I can't see from the top (can't get under it until tomorrow) where the coolant is...

Hello, Based on searching here I think my issue is the crankshaft position sensor, but there's something else going on so I'm hoping to double check... 2000 DII, 162,000 miles For past 2 weeks the engine has seemed to hesitate at idle, but the RMP gauge doesn't fluctuate when it happens...

Hello, I have a broken window roller (driver's) and have read on here about the fix, but the trouble is that I can't get the window down or up at all (it's about 1/2" from closed) and so I can't get to the second bolt that holds the glass to the regulator. Should I just drill a hole in the...

Hello, I searched but couldn't find this issue. At any rate, I have 2000 DII and just had a head gasket job in mid-March. I had replaced the coolant hoses, throttle heater, and plastic coolant piping prior to that. I was checking under the hood Friday and the coolant tank was about half-empty...

Just double checking, but... 2000 DII, 117000 miles. I'm getting the chirping bird noise over 30 mph or so. It disappears when I accelerate but returns most times when I let off the gas. Replace the front driveshaft? Or something easier? *The original driveshaft was replace around 75000 under...

Hello, About a month ago I got the 150 & 174 codes so I replaced that O2 sensor and erased the codes. Everything was fine for a couple of weeks. Last week the SES light came on and I got the same codes plus the P1174 one. I replaced the MAFS with a new Bosch one last night. I erased the codes...

Ahoy hoy, Engine light came on so I went to Autozone and got the following codes: P0150 O2 sensor circuit malfunction P0174 System too lean MAF or something else? Thanks

Hello, I'm hearing a disturbing noise. When I shift from reverse to drive I hear this loud clunk. It sounds like someone is giving a steel plate a sharp blow with a hammer. It is not the normal clunking sound. It's coming from this area at the front of the vehicle: Once in drive there's a...