Yeah. Real shame. Glad I finally got my Husky 10 last year.
Like you can rebuild the whole thing. But probably will never need too hopefully.
Didn’t they just move into a new building last year?
Does anyone have the file that was posted a couple years ago? There’s a 3D print bar near me and this would be a good excuse to go have a couple beers and give it a try.
Thanks,
Matt
Wiped it and sprayed it down. Had the wife try the brakes. Dripping down the rotor. Guessing it’s the caliper. Probably time to replace their original. It’s a ‘98 D1.
Short drive today. Pedal went soft and pulled hard to the right. After pulling in the garage and checking it looks like someone poured brake fluid on the coil spring and fender well. There?s a puddle on the rim. No leaks at master cylinder or ABS. Everything is dry as a Rover can be under...
Hey disco photo. Appreciate the help on the template. Hopefully get to install soon. Didn't see a post on Mantec so wanted to share. Glad to hear the sales are going well. Rovers North has always been a big help for me.
They have ceased to be.
Dealing with Rovers North about Mantec and they said Mantec ceased operations. Their website is down too. If your wanting something better get it now while someone has it in stock.
I have the same year and bleeder. Worked but it was a hell of a time after swapping lines. Took 4 or 5 bleeds to get out a large air bubble.
I did exactly what you did and realized I had to much fluid in the brake reservoir to start with. I had to lower to stop the overflow. Not sure it...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.