Search results

2000 Discovery 2 134K Just replaced throttle body gasket with kit today because I know they fail and it had a slight leak. I have had an on going coolant leak issue and after doing the throttle body today and starting the truck back up I noticed a pretty substantial drip from what appears...

What coolant for my Disco 2? I used the Land Rover XLC last time but now I have a leak. Still diagnosing the issue as the expansion tank only seems to go low after a few days. I have a new cap on order to test that first. Meanwhile need to know what pre-mix 50/50 solution I can use to top...

Hi, 2000 D2 134,500K Got some chirping going on and figure these boys need swapping out. I bought the kit from Atlantic British. https://www.roverparts.com/engine/kits/ERR6439K/ How hard a job? Tips, tricks? Torque settings? Thanks

So I passing the old 2000 DII ( 131,000 ) onto my 16 yr old son. Going on 23yrs old now I'm gonna need to replace some hoses etc. I've done alot over the years but lots of original parts. First task I believe will be the power steering pump. It has never leaked but I am worried about the...

Service Engine soon light came on and engine starting running rough. Like it wanted to stall. Drove just a few minutes and parked it. This was smoking. D2 - 2000. 131K.

The cold weather has caused my Master Brake cylinder to start leaking alot more. So i guess I need to either replace the whole thing or just buy a repair kit. Its leaking right under the reservoir pretty badly. Watched a few videos on the repair but was wondering if anyone had tips, things...

So when trying to swap the hoses that run from the engine through the firewall to the heater behind the dash i screwed something up. There is coolant fluid that leaks from behind the dash into the passenger floor board. How hard a job would it be to get to the heater core and reattach...

How do you swap the small brake lines out on the driver's side next to the frame? Seems very difficult to get behind that bracket.

At least i wasn't on the side of the road with a flat. I was working on the brakes and went to jack up the truck. Low and behold that POS jack was leaking oil and wouldn't go up at all. I haven't used it in years and luckily discovered it now. What's a good replacement that will jack up...

Thanks to all who have responded to my other posts about this issue. I'm lost. Symptoms - Bad grinding passenger front when applying the brakes. I have attached two pics to show the results on the pad (pic is from outside pad) and rotor. You can see a big chunk that has come out of my...

Anyone have experience with them? Good or bad? I know The Shop is an alternative in Atlanta but its a little further out for me.

Going crazy with this problem. Driving and braking at slow speeds, very little noise. Driving at higher speeds (35 or so) horrible grinding noise when braking hard. Release brake pedal and drive. No noise. Only happens when braking then goes away when driving. Doesn't happen when i...

How much fluid will come out as I am doing this? Should I bleed as I go or do it all the end? I will be replacing the front calipers as I go. Is there a trick for the small lines that have to be replaced on the driver's side front? https://www.youtube.com/watch?v=KdwCCZ43heE Decent...

Hello I was looking for some slightly used calipers and was wondering if anyone had experience with Roverlandparts.com? They have DII calipers for $85 a piece. http://www.roverlandparts.com/1999-2004discoveryiibrakecaliper-rightfront.aspx Atlantic British charges $150 a piece for new ones.

How hard a job is it to swap out the calipers? Or How hard is it to just use a re-build kit to change out the seals only. I have never done either and don't want to screw up a rebuild. Shop manual says to clamp the brake hose? I saw another trick where they placed a plastic bag over the...

I have an odd spot on the brake pad. See below. What could be causing this? Pic on the left with the arrow is outside pad - passenger front. Other pic is inside pad WITHOUT the same odd wear spot. I have a grinding noise when applying brake at low speeds. It doesn't happen each time i stop...

Strange Brake noise - Brake pad picture with odd wear Strange sound occasionally. Only happens at low speeds when stopping. Sounds like a low grinding noise coming from passenger front tire. The odd thing is that its not consistent. Maybe once every 15-20 stops then goes away. Brake pads...

So my cassette tape is stuck and I can't get the tape out. If i buy a used disco II radio from a junk yard is the radio code associated with the radio itself or the vehicle? I have my original code for the current radio but was wondering what happens when i install the new radio? thanks

I know this might start a long discussion but I want to try to keep things simple. Yes i did a search and am even more confused than before doing it. I need to change the fluid. I want to use the same orange i already have in there. 1. Will the prestone 50/50 work? It has the OAT Based...

So i want to figure this out before i am stranded somewhere. 2000 Disco II - 120K When i try to start it doesn't want to crank and sounds like its "slow" if that makes sense. When i immediately try it a 2nd time it cranks no problem. Just wondering if this is maybe the starter? No loud...