Search results

Worth buying used? If so, anyone have one? Thanks

Looking for transmission to fit 98 D1. Shipped to 82601, commercial address if it helps. Thanks.

When my truck sits, usually with a full or near full tank, it starts spitting gas back up the filler tube and all over the place. If I take the cap off it keeps coming out. The other day I undid both lines into the charcoal canister and the gas went down within a few minutes. Is this the...

Kinda backed into a pole in the middle of the damn street today. Well, not exactly middle, but who the fuck puts a 8" metal pole in the street?! I guess that's beside the point. Can someone (or multiple someones) advise on this? Not sure its worth it at this point. How much work is involved...

1998 D1 I'm in need of the hose/pipe that goes from the compressor to the condenser. Thanks, Zach

1998 D1. Looking for the line that comes out of the ac dryer/accumulator and goes back to the interior. thanks, zach

Looking for these for my 98 D1. New or known good used is ok too. Thanks, Zach

Looking for these for 98 D1, new and/or known/warranteed used is alright. Thanks, Zach

Anybody else see these retractable studded tires? http://www.automobilemag.com/features/news/1402-nokian-retractable-studded-tires/

Looking for a good condition used wiper motor. Front window, not rear. thanks, Zach

1998 D1, need an overflow tank, I broke the small plastic nipple. Quickly would be appreciated as well. Thanks, Zach

Looking for the following: Condenser Pipe going from the Compressor to the Condenser and the pipe going from the Condensor to the Drier/Receiver. Thanks, Zach

http://cgi.ebay.com/ebaymotors/Land-Rover-Other-Glenfrome-Convertible-1987-Land-Rover-Glenfrome-All-Terrain-4X4-Targa-Limited-/290887707388?pt=US_Cars_Trucks&hash=item43ba422afc

Looking for replacement air intake box. Thanks, Zach

Nevermind

I'm looking for both driver and passenger side switches for a 98 D1. (but if only one, then drivers) Also a good IACV if its out there. Thanks, Zach

Too good not to share this: http://boise.craigslist.org/bar/3199512671.html

Replaced the fuel pump yesterday, it ran great. Went to work this morning, it ran great. I was coming home a little while ago and it just died, in the middle of one of the busier streets in town. Turns over, acts like its not getting gas. If you leave it sit for about 5 minutes, then try...

98 D1. Looking for new or known good used one to swap in. Thanks, Zach

I have the injectors loaded back into the fuel rail, clips attached, and lubed up. How the fuckity fuck do you get the injectors to seat back into their holes??! Am I making this harder than I need to and just need to push more or am I missing something? I need a drink, thanks.