I am trying to order the front and rear prop shaft for my D2, they are at the measurements of front-610mm and rear-855mm long. But my vendor said the front should be 625mm and 840mm, as my truck’s power plant is sitting far too forward. The mount are on slots so basically some adjustment on it.
So here is the question, what is the easiest way but without an engine crane, I can push the engine with the tranny and t-case back an additional 15mm toward the back end of the truck?
thanks
Ed
So here is the question, what is the easiest way but without an engine crane, I can push the engine with the tranny and t-case back an additional 15mm toward the back end of the truck?
thanks
Ed