D1 slotted and drilled rotors, used

[Tree Trimmer]

Don't know if anybody would be interested but I just put new brakes on my D1. The slotted and drilled rotors went through 1 full set of kevlar pads on the front and little more than 1/2 set kevlar pads on rear. Were torqued properly when installed and taken off carefully as well. Was thinking about $10 each just for the hassle of selling them. In foothills area of NC. I travel around quite a bit though.

Tim

 

[d1driver]

Ever travel to Georgetown, Sc or Raleigh?

 

[super-poser]

PM Sent

 

[omar]

have you sold them yet?

 

[Tree Trimmer]

Yes I go to Gtown and Raleigh frequently, only I will be changing jobs after next Wed. There is a chance I will still be going down toward Raleigh even then. Probably not GT.

And no they are not sold, I just got back from PA. today.

 

[omar]

can i see a picture to get an example on how much they have left ! and if good ill take em!

 

[Tree Trimmer]

I'll mic them and post the thicknesses. I guess I should have done that before I offered them up.

 

[Tree Trimmer]

The rotors that were evidently in the front mic between .491" and .492". Sorry you'll have to do the metric conversion. The rears mic .528".

Tim