I am in the middle of pressing in new Radius Arm bushing (frame and axle ends) and while the frame ends went in fine, it seems as though the axle ends are slightly too large. These are the plastic/nylon wrapped bushings, not the typical steel wrapped bushings that were on the frame end.
They are measuring about 80 thousandths too big, can't quite figure out how to get them in without mucking them up. Wondering if all 8 are faulty (doubt it) or if there's just a "special" way that these are to be pressed in?
Any advice from folks who have done this?
They are measuring about 80 thousandths too big, can't quite figure out how to get them in without mucking them up. Wondering if all 8 are faulty (doubt it) or if there's just a "special" way that these are to be pressed in?
Any advice from folks who have done this?