JRdisco1 said:do you know what the cause of failure was? just curious I may need to check mines out....
garrett said:won't need balanced if you mark the shaft at the flange and tbox or other end. also good measure to install new u joints with grease fittings all pointing the same way. easier to service once installed.
roverover said:I found that the Spicers with the zerks way out there did change the balance I know on a short shaft ....... but I felt a small vibe that wasn't there before If my guy could balance the Rover shafts I would get it done
Yea she threw me with the right pass side too sounds like pads