Name that R380 Mystery Part and Help with Hardware

[t42beal13t]

I'm wrapping up replacing the clutch on my '95 D1 and seem to have misplaced the hardware for the "inspection plate." It's the plate that bolts to the bottom of the bellhousing and covers the backside of the flywheel.

What's the LR term for the plate? What hardware does it use?

 

[listerdiesel]

I can check on Microcat later, I'm at the factory right now.

The bolts will likely be 5/16" NC or 3/8" NC hex head, looks like you have two dowel holes there as well?

Peter

 

[listerdiesel]

OK:
Two bolts (no size given, but they are M8) 594134
Two lockwashers M8 WM109001L
Seven M6 X 26 hex head bolt FS106255L
Seven lockwashers WM106001L

Hope this helps.

These go into the ZF box not the engine, I was think of engine bolts in my post above.

Peter

 

[t42beal13t]

I think that's what I need. Now to find the hardware. Thanks!!

 

[ptschram]

Some of them are goofy tapered fasteners. When you find them, you'll recognize them.

 

[t42beal13t]

They were actually in the pocket of the pants I was wearing when I removed them a few weeks ago. Such a relief.