RRC passenger side rear lamp guard

Tugela

Well-known member
May 21, 2007
3,954
15
Seattle
Some bastard visigoth barbarian swine ripped off one of my rear lamp guards. Yanked it straight off, broke my fancy new aluminum hardware and everything. If anyone has a single passenger side rear lamp guard sitting around gathering dust, I'd like to buy it. This is the style that plugs into the rubber wedge on the quarter panel. Thanks.

Also, if anyone has a link to where I can buy new aluminum mounting hardware, please post it. I can't find where I bought my last set.
 

Tugela

Well-known member
May 21, 2007
3,954
15
Seattle
Thanks. I found a lamp guard and tracked down the vendor who sells the aluminum mounting hardware. It's out of stock at the moment but they expect more in May. I should be set - tentatively.
 

luckyjoe

Well-known member
Oct 10, 2004
228
2
New Jersey USA
Thanks for posting - I need to get that hardware kit. I took my rear lamp guards off a couple years ago but never decided how to best remove the factory coating...
 

Blueboy

Well-known member
Apr 20, 2004
1,959
6
Back in the USA; Rockwood, PA
Great to hear you’re all set.

My Rangie had them from the PO and one of the first things I did was remove them.

There are many low hanging branches and what not where I take the Rover and my feeling is they can be easily snagged, ripped off, and then leaving holes in the mounting points.

Just something to consider.
 
  • Like
Reactions: Tugela

Tugela

Well-known member
May 21, 2007
3,954
15
Seattle
I agree, the lamp guards have the potential to cause damage from exactly the hazard they are meant to protect against. I also off-road my Rovers in forested terrain but I keep the lamp guards installed for the originality. They came factory on my uncommon 93 Sport and I am trying to maintain it as close to stock as possible (with a few aftermarket parts that deviate from factory - shocks, tires, distributor, etc.).
 

Tugela

Well-known member
May 21, 2007
3,954
15
Seattle
No brush bar. Even better: front lamp guards! Here's a photo. The previous owner bent the bumper. I have a replacement in my garage, just need to make the time to install it.
DSCN2609.JPG
 

Attachments