Greetings!
Need some ideas on a problem with my 02 DISCO II SD with ~52K, have detected a vibration under load at approximately 2500rpm or greater.
Have recently completed the following repairs or upgrades:
-[FONT="] [/FONT]Installed a Great Basin Rover rebuilt front drive shaft
-[FONT="] [/FONT]Installed a Old Man Emu steering dampener
-[FONT="] [/FONT]Installed DBA rotors and Kevlar brake pads front and back
-[FONT="] [/FONT]New stock Michelins
-[FONT="] [/FONT]Seafoam flush, great results by the way!
-[FONT="] [/FONT]Transmission filter and fluid changed
-[FONT="] [/FONT]Diffs and transaxle fluid changed
-[FONT="] [/FONT]Greased where required
-[FONT="] [/FONT]New belt tensioner and idler pulley
Motor mounts and rubber coupling on rear shaft looks good. Not sure when the vibration started, but I did not detect the vibration prior to installing the drive shaft and steering dampener.
Q1.) Is there any special alignment of the front shaft that is required during installation?
Q2.) Is there a way to safely drive a 02 without a front drive shaft?
Any suggestions!
Thanks!:banghead:
Semper Fi
Need some ideas on a problem with my 02 DISCO II SD with ~52K, have detected a vibration under load at approximately 2500rpm or greater.
Have recently completed the following repairs or upgrades:
-[FONT="] [/FONT]Installed a Great Basin Rover rebuilt front drive shaft
-[FONT="] [/FONT]Installed a Old Man Emu steering dampener
-[FONT="] [/FONT]Installed DBA rotors and Kevlar brake pads front and back
-[FONT="] [/FONT]New stock Michelins
-[FONT="] [/FONT]Seafoam flush, great results by the way!
-[FONT="] [/FONT]Transmission filter and fluid changed
-[FONT="] [/FONT]Diffs and transaxle fluid changed
-[FONT="] [/FONT]Greased where required
-[FONT="] [/FONT]New belt tensioner and idler pulley
Motor mounts and rubber coupling on rear shaft looks good. Not sure when the vibration started, but I did not detect the vibration prior to installing the drive shaft and steering dampener.
Q1.) Is there any special alignment of the front shaft that is required during installation?
Q2.) Is there a way to safely drive a 02 without a front drive shaft?
Any suggestions!
Thanks!:banghead:
Semper Fi