sounds to me like the trans torque converter is bleeding down.
try starting it up wait about 2-3 mins and see if pulls
if all the fluid is in the trans pan it takes a min or two to get the trans fluid to circulate and make the trans work
need to reset base idle and timing needs to be set to about 9 degrees
set base idle by closing off the idle air control valve(vise grips on the big hose coming from the idle air control valve) and setting the idle to 550 rpm
also clean emmision pipes I've seen carbon clog up in that t-piece...
1313 AND 1314 KEEPS TURNING THE LIGHT ON . FIRST HAD MISFIRE CODES FOUND VALVE STICK NO PROBLEM. DID HEAD JOB NEW EXHAUST VALVES, PLUGS,WIRES, EVERTHING. FIXED FOR ABOUT 2 WEEKS. NOW I KEEP GETTING 1313,1314 . CHECKED THE RELUCKTER RING ON THE FLYWHEEL GOOD REPLACE THE CRANK SHAFT POSITION...
One Of Two Things Happened. One Is The Lights Came Because You May Have A Faulty Sensor Or Two The Computer May Have Set Back To Air Suspension Again, And Is Turning On The Lights Because You Now Have Coil Spring
May The Force Be With You :)
CHECK THE AIR FILTER BOX THE LID IS PROBABLY NOT INSTALLED CORRECTLY IF THE AIR BOX HAS ANY BROKEN OFF TABS THAT LINE UP THE UPPER AND LOWER PARTS OF THE AIR BOX OR THE PLASTIC HOUSING IS WARPED THE WHOLE AIR BOX NEEDS TO BE REPLACED ,IT WILL COME WITH A NEW AIR FILTER INSIDE IT ;) . ALSO THE...
open the glove box and see if the light in there has come loose
i have seen the bulb holder come loose and the contacts short out to the the metal dash causing the instument lights to go out
good luck greg
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.