My passenger seat back refuses to go forward. Doing some searching led me to the "pull the cable and insert into drill" method. So I pulled the cable out of the motor and started with the drill. Looked to be moving ever so slowly and then stopped. The cable runs from the motor, under the seat...
Thanks pm. I'll try removing the driveshaft and see if the vibration is gone.
Could the rear radius bushing to chassis cause this? My driver side bushing is pretty loose
So I think something in the rear is slightly binding. There isn't any noise but more of a feeling while driving. It's almost like rolling over a slightly washboard road. It feels like it's coming from the rear. Nothing crazy and probably only something a long time owner would notice with their...
I did this exact thing in my 98 Disco. I used the link above for my swap, it's pretty thorough. Definitely swap the front cover. I think I used the gems front cover, intake manifold, crank sensor and oil pan.
Change as many orings, gaskets etc etc as you can with the engine out. I used the 4.0...
Last summer I swapped the 4.0 out of my 98 Discovery for a Bosch 4.6. Used the Frankenrover website to pretty much guide me through it. So basically it is a 4.6 block and heads with everything else from the 4.0.
She ran fine after it was all said and done except the head gaskets started to...
Picked up a Salsa Spearfish a couple years ago for relatively cheap. I think its a 2013 model with full suspension 29er that has handled everything I've thrown at it so far.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.