104k I have the exhaust loose cause of putting in a cas so i dont think cats could affect that as of right now. I got to the fuel pressure port not as bad as was described on the internet. only getting 10 psi at the rail. looking for the pressure reg to disconnect.
Thanks.
And buddy i havent was looking for the pressure port and found i have to remove the intake manifold to get to it ? does that seam right . usually you can get to a port fairly easy.
I having trouble with the Disco 2. It will start and die almost instantly. Some times if i hold the gas pedal down it will run past 2k then either start dying or slow die out.
I replaced the CPS with a used one same thing. Cleaned the Iac valve was nasty. Can unplug the Iac and get it to run...
Had a few codes pointing to rear O2 sensors being bad. So i replaced them with new (cheap ones i know) cleared the codes. Drove around for 10 mins now im getting 2 codes 0141 0161 heater open fault something. So i reset the codes again and would not pop one until i rested the truck and...
Why cant both be right ? GO to the news station and tell them what happened. I bet they have one of those ask bob things. Sounds like you got hosed by the shady dealer. Sorry for your luck.
i would need more specs but 7000 watts is 58 amps now you might not have every thing on in your house. A normal breaker panel is 150 plus. I would need the actual specs cause usually the box lies. Also if you have auto switcher it starts getting expensive.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.